80mm Fanholder
Description
I Wanted A Simple Way To Mount A Fan On My Solidoodle3, But Finding An Elegant Design Was Tough Because I Had An E3D Hotend Installed. In Desperation I Put A Magnet On A Screw In The Corner Of An 80Mm Fan That I Had Directly Wired To A 12V Power Supply And Stuck It To The X Axis Rods Where It Sticks Out The End Of The Carriage - And It Worked! With This In Mind I Created A Very Simple Holder Than Uses 4 8Mm Magnets And Two Screws And 2 Nuts. There Is Not Gluing Required; Everything Can Be Disassembled If You Don'T Like It! This Design Also Cools One Of The Motors.
Statistics
Likes
2
Downloads
0