Cooling Fan/Shroud with 4cm Blower and Sensor for Wanhao D6/Ultimate
Description
This Shroud Is Printed In Two Parts That Slide Together. Included Is A M12X1Mm Nut For The Proximity Sensor. You Also Need To Print Two Of The 5X6Mm Posts And Remove A Small Bridge Between The Holding Posts For The Fan On The Shroud. I Used A Gdstime Technology 24V 0.1A 40Mm Blower. At 100% The Output Is About What A 50Mm Blower (Http://Www.Thingiverse.Com/Thing:2235389) Does At 25-30%. 2X 10Mm M2 And 2X 12Mm M2 And Nuts To Fix The Fan In Place The Probe Is The Omron Manufacturer Part #: E2B-M12Kn08-Wp-B1 2M Which Is Pnp And It Works With A 7805 To Reduce Voltage Down To 5V And The Pnp Configuration.H Of The Marlin Duplicator 6 Firmware. This Probe Has A Working Distance Of 8Mm In A M12 Form Factor. Screw The Probe In So That It Is Flush With The Bottom Of The Shroud. This Setup Works With A 1Mm Pei Sheet Glued On The Build Plate. Same Position As In 1Bigpig'S Probe Mount Http://Www.Thingiverse.Com/Thing:2081168 Where You Also Find The Description On How To Set Up The Probe.
Statistics
Likes
22
Downloads
0