Nintendo Switch rotating and detachable wall mount (No scratching)

Description

Video Of Assembly And Use: Https://Youtu.Be/Rfcn4Xdv-Yo I Made This Nintendo Switch Wall Mount, As I Like To Play The Switch In My Bed, But Its Not Very Comfy To Hold The Switch While Laying In The Bed, And I Like To Lay Sideways And Play. So I Made This Wall Mount That Can Turn Into Any Angle You Like, So You Can Play While Laying On Your Side, It Can Of Course Also Be Used As A Normal Wall Mount. The Wall Mount Is Detachable And Uses A Module System, This Means That You Could Make A Normal Stand That Had The Module Connector And This System Would Work Too, Im Planning To Do This In The Future, So Its A Multi Tool. If You Wanted You Could Also Use This System For Making A Mount For The Car. There'S A Hole In The Bottom So The Switch Can Charge While Playing. I Made The Holder Specifically For Not Scratching The Switch, As That Has Been A Problem For Some. The Case Only Touches The Metal Rails And The Two Holes In The Bottom Remember To Print In Right Orientation, Especially The Holder That Slides On The Switch, The Indents Should Be Facing Upward If They Don'T Connect Correctly, Try Cutting The Edges Of The Holders Module Connector. If People Like It I Will Make A Stand That Uses This System Aswell So You Can Seamlessly Switch Between Using A Stand And A Wall Mount Settings; Printed In Green Pla 2 Mm Height 50 Mm/S Speed

Statistics

Category

Tags