Magnetic Bracket for Enclosure - 1" Remix
Description
Saw This Design And Wanted To Use It, But I Didn'T Have Any Of The Required Magnets. I Did Happen To Have 1" X 1/32" N52 Neodymium Rare Earth Magnets From An Earlier Project. If You'Re Interested In Them, Here'S The Link: Https://Www.Kjmagnetics.Com/Proddetail.Asp?Prod=Dx001-N52 Also Added A Cross-Section View Of How I Adjusted The Screw Cap. I Left ~0.5Mm Gap Between The Bracket And Screw Cap, Just So I Wouldn'T Have To Sandpaper The Sides Down If It Was Too Tight A Fit. I Also Left 0.9Mm Gap For The 1/32" Thick Magnet. If This Turns Out To Be Too Little Or Too Much, I Can Adjust Accordingly And Re-Upload. Once I Have These Printed, I'Ll Add Pics. Oh, I Also Added Some Fillets Just Because :) I Prefer Less Blocky Designs. It May End Up Needing Them Without The Curves, So I'Ll Re-Upload If Needed. Cheers!
Statistics
Likes
3
Downloads
0