Dual Titan Aero for Taz 5
Description
This Is A Quick And Dirty Carriage For Dual Titan Aero On A Modified Taz 5 Using Piercet'S Openbuild V-Slot X Upgrade (Https://Www.Thingiverse.Com/Thing:866604). It May Work On An Un-Modified Taz 5, But I Haven'T Tried It. The Actual Holder Is Based On Pcsentinel'S Dual Holder (Https://Www.Thingiverse.Com/Thing:2240611 ). I Modified It To Screw And Heat Insert Onto A Modified Taz 5 X Mount Which Screws Onto An Openbuild 20X80 Universal Gantry. This Will Allow Me To Test It On My Gantry Without Removing My Entire Carriage. My Offset Settings: Right Extruder: //#Define Hotend_Offset_X {0.0, 44.8} // (In Mm) For Each Extruder, Offset Of The Hotend On The X Axis //#Define Hotend_Offset_Y {0.0, 0.00} // (In Mm) For Each Extruder, Offset Of The Hotend On The Y Axis M218 T1 X44.80 Y0.00 Bltouch: //#Define X_Probe_Offset_From_Extruder 21 // X Offset: -Left +Right [Of The Nozzle] //#Define Y_Probe_Offset_From_Extruder -32 // Y Offset: -Front +Behind [The Nozzle] //#Define Z_Probe_Offset_From_Extruder -2.04 // Z Offset: -Below +Above [The Nozzle] There Is A Little Gap In The Horizontal Of The Extruder Holder And The Mount Plate. This Will Allow You To Shim The Angle A Few Degrees To Straighten Your Nozzles. I Am Using 2 Different Nozzles Which Are Not The Exact Same Length. (Hardened Steel E3D And Ruby Olsson) I Will Add A 30Mm Adapter Plate (30Mm_E3Dv6_Fan_Adapter.Stl) If You Want To Re-Use The Fans You Have From The E3D V6 Fins, Or Any Other 30Mm Fan For The Filament Cooler. Current Fans Keep Hitting The Back Right Corner Bed Plate. I Need To Redesign. This Was Mocked Up In Tinkercad, So It'S A Bit Less Than Pristine. If You Can Clean It Up, Please Do!
Statistics
Likes
19
Downloads
0