Prusa i3 MK2 - Extruder Fan Shroud (30mm)

Description

This Is A Fan Shroud That Clips Onto The 30Mm Extruder Fan Of A Prusa I3. It Helps Direct Air Into The Inlet Of The Fan, And Prevents Wash From Being Thrown Out Of The Side Of The Fan Onto The Print Bed. When I First Started Printing Abs With The Prusa I3 Mk2S, I Noticed Some Wash Coming Off The Bottom Of The Fan For The Extruder. This Caused The Back Left Corner Of All My Prints To Warp Severely. Since Installing It, I Have Not Had An Issue With Warping And I Cannot Feel Any Air Escaping The Sides Of The Fan Inlet. Installation Note: One Side Of The Clip Is Offset Slightly Lower, This Goes On The Back Or Left Side Of The Fan. There Is A Plastic Piece On The Extruder Body That This Clip Goes Below.

Statistics

Category

Tags