Filament runout sensor case and cleaner
Description
This Is A Clip-On Body That Holds The Runout Sensor (Endstop Switch) For An E3D Full Metal Pro Flex Extruder From Tevo Tarantula. First You Clip The Body Onto The Metal, Than Put The Endstop Into The Body And Finally You Can Clip On The Cover. The Cover Is Easily Removable So I Can Switch The Sensor From Extr1 To Extr2 Depending Which One Needs It. Cut The Foam Piece A Bit Bigger Than The Holder, It Has Some Gripper Edges So It Is Contained. In Marlin: Config.H: Enable The Runoutsensor By Removing The "//" Before This: -#Define Filament_Runout_Sensor Than In The Pinramps.H: Blank Out The Z_Max_Pin By Adding The "//": -#Define Y_Min_Pin 14 -#Define Y_Max_Pin 15 -#Define Z_Min_Pin 18 -//#Define Z_Max_Pin 19 Go Down This .H File Where The Actual Runout Is Defined And Change The Pin To 19 -#Define Fil_Runout_Pin 19
Statistics
Likes
15
Downloads
0