Tronxy X1 bed tightener
Description
Update: Edited Part A And B To Leave More Room For The Bearings, So They Don'T Rub. A Screw Controled Tightening System For The Tronxy X1'S Sometimes Wobbly Y-Bed. I Did Previously Use The Model From Pb2000 Https://Www.Thingiverse.Com/Thing:2203872 , But Either I Was Doing Something Dumb, Or My Matrial Wasn'T Good Enough; The Bed Started Wobbling Again After A Couple Prints. Part C And D Are Optional And Made To Fit The Spare M5 Screw I Had Leftover. Required Is A M5 Nut + A M5 Screw With 25Mm Length (Without Part C+D) Or 30Mm Length (With Part C+D) Suggestions Or Requests Are Welcome!
Statistics
Likes
111
Downloads
0