Geoff's GT2 Timing Belt pulley Mk2 - fully 3D printed
Description
Upgrade To My Earlier "Geoff'S Gt2 Timing Belt Pulley", This Version Does Not Use A Grub Screw Which Marks The 5/6/7Mm Rod, Making It Much Easier To Slide The Pulley Off The Rod For Maintenance. I'Ve Also Changed The Teeth Shape To More Closely Match A Gt2 Belt, As You Can See In The (Partial) Red Pulley & Gt2 Belt Pic The Only Assembly Needed Is To Push A 3Mm Screw&Nut Into Each Hole - The Length Varies With Diameter, Approx 18-22Mm. You May Need To Drill Out The Center, Depends On Your 3D Printer Calibration Setup. Included Are 16T, 18T, 20 And 22T Pulleys, Each Size With 5/6//7/8Mm Centers (Except Where The Walls Are Too Thin) - Pm Me If You Need Other Sizes
Statistics
Likes
78
Downloads
0