Final Design for Press Reset Challenge #SKATEFORCE (Single stud wall mount-smoothed out trucks holder)

Description

This Was Tested With All Of The Weights I Have At 46Lbs, The Thing Didn'T Even Budge A Little. It Was Solid As A Rock. The Print Material Was Done With Zyltech Pla 1.75Mm. (Cheap Stuff $11.45 Per 1Kg On Ebay) It Is Not The Greatest To Work With But It Proves That Even Cheap Filament Can Hold A Ton Of Weight. The Print Settings Were 210C And 65C On The Bed At 60Mm/S With 25 Percent Infill. The Time It Took To Print Was Just Over Seven Hours. This Was Secured To The Wall With Just One-Inch Long Roofing Screws As That Was All I Had To Fasten With. If I Can Find More Weight I Will Try Again. Anyway Thanks For Looking. (Also It Was Printed With No Supports And There Is A Version Without The Logo Too) Final Design For Press Reset Challenge #Skateforce See Link For Challenge Contest: Https://Www.Youtube.Com/Watch?V=Pvh-Gfd4Sfo&T=1S

Statistics

Category

Tags