Printrbot Simple Metal Y-axis Cable Holder
Description
A Modification Of "Cable Chain" By Modelstation. My Changes Include Eliminating One Wall Of The Chain Pieces So You Can Slide In The Cables Headed To Your Extruder Stepper And Hot End Without Detaching Any Wires. This Set Of Wires Always Seem To Droop Into The Build Plate On The Printrbot Simples, This Worked As A Solution. I Also Added A Chain End And A Stepper Motor Mount. You'Ll Need Some 35Mm M3 Screws (A Little Bit Longer Than The Stock Stepper Screws To Allow For The Space The Mount Takes Up). I Found Some Flathead M3X35Mm At My Local Hardware Store. I Left The Wires In The Sleeving That The Pb Simple Comes With But Did Cut It Down A Bit On Either End, I Then Used Small Zip Ties To Secure The Wire Sleeving With The Wires Inside To The Vertical Pillars On Every Other Chain Link. It Keeps Your Build Plate Clear And Looks Pretty Cool.
Statistics
Likes
11
Downloads
0