1 Relay Board Enclosure (for "Low Level Trigger" relay)

Description

This Enclosure Is For 1 Relay Board 5V (Low Trigger), It Sells On Aliexpress For Us$0.60. Link: Https://Goo.Gl/Przna9 To Hold The Board, You Must Use Hot Glue To Stick The Relay To Bottom Enclosure, And To Close The Enclosure Permanent You Must Glue The Lid To Enclosure. It Took Almost 40 Mins To Print. At 0.15Mm Resolution. Note: Just A Note, Not Relevant For The Enclosure. This Relay Does Not Work Good On Raspberry Pi, Because It Is A Low Level Trigger, I Use A Workaround To Make It Work; Set Gpios To In Or Out Instead Of High Or Low To Make The Relay Switch. Im Also Test This Relay With Esp8266 Esp-01 Module Standalone And With This It Work Perfect. Here Is The Link For The Esp8266 Esp01 Module: Https://Goo.Gl/Ryd1Ox.

Statistics

Category

Tags