TX03 Mount for Eachine Micro Skyhunter
Description
This Is A Remixed Tx03 Camera Mount Designed For The Eachine Micro Skyhunter. Not Yet Tested; But Designed To Screw Into Pre-Drilled 20Mm Separated Holes On The Canopy Section. Holes On The Mount Are Designed To Take M2 (2Mm) Self-Tapping Screws To Affix To The Fpv Canopy, And Will Accept Screws With Heads Up To 6Mm (Which Should Include Flanged Heads Too). Also Added A Flat Front And Gradient Edge To The Camera Base To Allow For Support-Less Printing. Rounded The Back Edges Off For Aesthetics And Weight Reduction. Retained The Zip-Tie Gap Under The Camera (Enlarged As I Only Have Slightly Too Big Ties For The Original Hole Size), As I Plan To Loosely Ziptie The Camera To The Mount As A Backup. Will Screw (And Hot Glue To Be Safe) The Mount Itself Into Place On The Plane (Note: These Cameras Often Get Too Hot For Using Hotglue To Secure It In Place). I Printed At 3 Wall, 1.2Mm Top+Bottom, 100% Infill, And It'S Looking Good. Very Light And Strong In Pla.
Statistics
Likes
13
Downloads
0