Anet A6 level adjuster
Description
That Is An Ajuster Of Extruder Level Over A Heating Bed. Requirements: 1X Screw M3X30 (Or Some Longer) 1X Nut M3 1X Spring ~15Mm To 5Mm With 4..6Mm Diameter. 1..2 Washers For The Spring (Optinal) You Have To Check Free Movements Of Shift Inside Of The Base Part Before. It Could Be Assembled Without Printer Disassembling. Just Move Head Along Of Z-Axis For A Few Inches. The End-Switch Should Be Mounted With Roll To Inner Side Of Printer. The Screw Should Be Fixed Tightly In The Base Part After You Assembled It.
Statistics
Likes
7
Downloads
0