Removable transport handle for Microcube

Description

This Handle Can Be Quickly And Easly Clip On The Frame Of The Microcube, To Transport It. It Require Some Sewing Material And Competences. **You'Ll Need:" - 2 X Soft_Handle_Support.Stl - 2 X R_Soft_Handle_Support.Stl (Reversed One) - 2 X 8Mm Tube 70Mm Long (You May Have Scraps Of The Microcube Structure) - A 40Mm Width 40Cm Long Strong Tissu For The Handle Itself. And Beld Or An Old Bad Strap For Example. I Use A Piece Of Judo Belt (3€ In Any Sport Shop). It Must Be Tick And Strong. - Super Glue - Sewing Needle, Good Strong Thread **Instructions:** - Print The Parts - Make A Handle Terminal Using A Soft_Handle_Support And A R_Soft_Handle_Support, Inserting Them In Each Side Of A 8Mm Tube. Glue Them On The Tube To Be Sure It'Ll Never Move. Ensure The Hooks Of Each Printed Part Are Aligned, And Distant By 70Mm. The Best Thing Is To Clip The Item On The Microcube Structure, On The Rear Top Tube (In Its Final Position), And Wait A Few Hours For The Glue To Get Strong. - Make The Second Handle Terminal. - Fix A End Of The Belt To A Terminal: - Make A Hem At The End Of The Tissue Belt If Needed. - Place That End Around The Rod Of A Terminal, Having The Belt Covering Itself On 30-40Mm On Its Bottom. Take Care Of The Side (Look At The Picture). - Sew It Tight And Strong. - Then Sew It Again To Be Sure (We Don'T Want Our Precious Microcube To Fall On The Floor And Broke). - Fix The Other Belt End To The Other Teminal, **After Checking And Adjusting The Length To Your Need**. Take Care Of The Side Of The Terminal, The Hooks Of The Teminals Must Clip From The Outside To The Inside, To Better Mechanical Resistance. I Sew The End Belt On The Bottom Of It Once Clip On The Printer, For Aesthetic. If You Are Not Confident Enough With Your Sewing Skils, Sew It On The Top, It Will Be A Bit More Resistant. Or Better: Ask Someone That Can Do Strong Seam :) Et Voilà! Now You Can Clip And Un-Clip The Handle In A Few Seconds To Carry You Microcube.

Statistics

Category

Tags