Titan extruder mount
Description
*Edit* I Added A File To Mount To The Right Side If You Are Looking At It From The Outside. I Also Slimmed And Smoothed It Out Some. I Made This Mount With The Intention Of Going To Full Bowden On The Little Monster. I Think Its One Of The Best Additions I Have Made To The Printer. This Should Just Need Minimal Clean Up With A Hobby Knife Clean Up. The Mounting Holes Were Made For M4 To Use With T-Nuts On 20X20 Style Extrusions. I Have Mine Mounted On The X (Alpha) Tower With The Screw/Knob Facing The Tower. It Works Well For Faster Filament Changes. You Will Need To Up Your Retraction A Lot. I Recommend Starting At 7Mm And Going From There. Update 6-18-17: I Modified The Current Mount To Allow More Room For The Thumb Wheel For Those That Have The Real E3D Titan. I Also Found That The Spacer Makes It Too Thick, And The Stepper Shaft Can'T Reach The Stabilizing Hole In The Titan Cover. So I Narrowed The Center Section On The Update. I Added A Vers.6 For Better Thumbscrew Clearance.
Statistics
Likes
119
Downloads
0