JeVois Camera Tripod Adapter
Description
This Is An Initial Attempt At Creating A Basic Jevois Camera Module Mounting Plate That Will Fit Common Tripods And 1/4" Unc Bolt Fixings. I Used The Mounting Pattern From Http://Jevois.Org/Doc/Casemounting.Html - The Official Documentation State That The Jevois Case Mounting Holes Are Spec'D For M2.5/2-56 Screws, But I Found That M2 Screws Had The Right Diameter To Bite The Plastic Without Being Over-Tight. I'D Recommend M2X6 Screws To Account For The 1Mm Countersink In The Plate - I Also Used An M2 Washer On Each Screw. The Unc Nut Fitting Is Tight But Does Require A Small Dab Of Superglue To Retain It. The Openscad File Is Included If You Need To Make Tolerance Tweaks For Your Printer.
Statistics
Likes
15
Downloads
0