Anet A6 Spool Holder (Hook on / Bench)

Description

New Designed Filament Spool Holder For Anet A6. This Spool Holder Will Not Cause Any Unravel Of Filament During Printing Which Is The Major Cause Of Filament Jam And Snap Filament. Revised Side Holder For Better Clearance When Holder Is Placed On Table This Is The Best Spool Holder I Ever Used After I Have Gone Through About 6~7 Spool Holders. It Requires 4 Pieces 608Zz Bearing And 2 Pieces Of 200Mm Length M8 Threaded Rod And Nut 4~8 Pieces

Statistics

Category

Tags