Single VESC Enclosure / Case
Description
This Vesc Case Mounts To Your Board With 6 Screws (The Picture Is Old, Sorry), And Holds The Controller Snugly. Best To Add Lots Of Foam Or Insulation Tape To Prevent Rattling. Includes Usb Port Cutout And Wire Combs For Phase Wires, And Battery Wires. Allows Room For A Nrf Chip, Gt2B Receiver, Or Any Smalll-Ish Pcb Over The Capacitor Bank For Minimal Interference. Routing The Antenna Away From The Vesc Is Still A Good Idea (See Picture). Don'T Print Skate Parts In Abs Or Pla! They Won'T Hold Up, And You'Ll Be Disappointed When Your Vesc Falls Onto The Ground At 40Mph. Petg Works Good, And It'S Cheap.
Statistics
Likes
35
Downloads
0