Fine tuning FormLabs Form1/1+/2 Fine Tuning
Description
You Can Get Better Prints By Knowing About The Errors In Your Form1+. You Can Even Print This At The Same Time As Other Models So You Don'T Have To Do A Special Run. And If You Post Your Results, We Can Discover What Is Typical Is Too. And Then Measured It With A Digital Caliper. And From The Various Measurements: X-Scale = 0.50% Too Big Y-Scale = 0.10% Too Big X-Offset = 1.35Mm Too Far Toward Hinge Y-Offset = 0.85Mm Too Far Toward Front Z-Loss = 0.643Mm Platform Height = Full Adhesion, Do Not Adjust. Z-Scale = (Can Only Be Properly Tested With A Tall Model And Supports Under It, Not Included Here) Excel File For Help Tuning Https://Forum.Formlabs.Com/T/Calibrating-Models-For-The-Form1/2545 Https://Forum.Formlabs.Com/T/Resin-Tray-Calibration-And-Adjustment/4616/3 Https://Forum.Formlabs.Com/T/Gear-Surface-Deformation/1999/6 Based On: Https://Forum.Formlabs.Com/T/Print-Better-By-Discovering-Your-Form1-Advanced-Calibrations/1852 Other: Http://Forum.Formlabs.Com/T/Test-Cube/413
Statistics
Likes
6
Downloads
0