Portable Microphone wire holder
Description
This Is A Simple But Very Useful Project. I Wnated To Protect And Organize The Cable For My Microphone In Order To Keep It In Good Shape And To Avoid Breaking Of The Cable Or To Not Allow The Cable To Tied It Self Up With Impossible Knot To Undo ;-) It Can Be Used For Haedphones As Well!! Instructions: There Will Be 2 Stl Files. One Which Doesn'T Require Any Support Material (I Really Reccomend This For A Better Result) But You Have To Glue The Two Parts Together And The Other One Which Is All In One Piece But It Does Require Support Material. - 2 Parts File Once You Have Printed It Sand Really Well The Two Meeting Faces Then Take A 3 Mm Drill Bit And Insert The Two Parts With A Small Gap Between Them, Then Apply Ca Glue On The Two Meeting Faces And Clamp Thoose Together For 2 Minutes. Finally Take A 3.5 Mm Drill Bit And With A Drill Enlarged The Hole That Should Eliminate Any Miss-Allignment And The Microphone Jack Shuold Fit In It Nice And Tight. To Finish It Just Use A Bit Of Sand Paper. Look The Pictures For A Better Explenation - 1 Part File Just Print It, Remove The Support Material And Use The 3.5 Mm Drill Bit And The Drill To Enlarged The Hole For The Microphone Jack And Finally Use Sand Papaer To Refine The Tear Out Left By The Drill Bit.
Statistics
Likes
13
Downloads
0