80mm Fan Inlet/Outlet for Camping and more
Description
Update 10.Jun. 2017: Replaced "80Mmfanoutsideinnlet.Stl" -> With Better Stability And Also Printable Abbiltys. The Side With The Opening, Without The Net-Structure And Additional Edge Should Faced Down On The Heatbed For Best Printperformance! Watch The Screenshot From Cura! This Are My Solutions For My Camping-Caddy To Get Fresh Air While Sleeping. Two 80Mm Fans Bring In And Out The Air Of The Caddy. The Outside Covers For The Fans Are Mainly For Weather-Protection. So There Is A Drip-Edge For The Outside Inlet While Its Raining That Should Help To Get No Additional Water Inside The Car. Also The Inside Covers Have A Functional Background. So Should The Insideoutlet Took The Bad Air From The Top Of The Car Outside. The Inlet Blows Wide In The Car With A Angled Nozzle. The Fans Will Controlled From A Arduino. The Arduino Is Getting Data From Inside And Outside Of The Car. Because It Makes No Sense To Run The Fans All Night Long. I Will Link The Arduino-Sketch After My First Realtime-Test...
Statistics
Likes
34
Downloads
0