Death Star Fidget Spinner
Description
This Is About 70% From The Pokeball Fidget Spinner By Thedesignerd With 20% From The Death Star By 3Dmax And The Remaining 10% My Extremely Limited Tinkercad Skills To Modify Those 2 Designs. I Take Very Little Credit Myself. As With The Pokeball Spinner, This Uses M8 Nuts For Weights (I Used 5/16 With A Little Glue). You Will Also Need To Super Glue The Top And Bottom Of Each Death Star To The Body. The Top And Bottom Death Star Pieces Are The Only Ones That Should Be Printed With Supports. 10-15 Percent Infill Was Enough For Me For All Parts (Although I Normally Do The Caps At 100%). 6/10/17 - Added A Slightly Longer Cap As The Original Could Rub Against The Body Depending On Bearings, Printer Settings, Etc. Both Are Available. As This Is A Remix From Designs That Specify Non-Commercial Use, Please Respect That For This Design As Well.
Statistics
Likes
58
Downloads
0