Original Prusa I3 MK2 PSU Top Cover
Description
Top Cover For The Psu Of The Prusa I3 Mk2(S) I Was Missing A Top Cover For My Prusa I3 Mk2S So I Designed One That Is Aesthetically Pleasing Following The Shapes Of The Original Designs. For Mounting You Can Just Slide It Over The Top Of The Psu. A More Permanent Solution Would Be To Use Some Double Sided Tape On The Inside Of The Top. Or Drill Some Holes On The Top Where The Screws Of The Psu Are Currently Located. It Can Be Printed In Pla Or Abs, The Psu Does Get A Bit Warm, But I Do Not Think It Will Be Over 40 Degrees, So Pla Should Be Fine. If You Are Worried Of The Amount Of Heat From Your Psu Then Use Abs As Filament. It Does Not Need Any Supports, But You Can Put Some Supports Underneath The Text If Wanted. <Iframe Src="Https://Myhub.Autodesk360.Com/Ue2B51Acd/Shares/Public/Shabee1Qt1A327Cf2B7Ac61325D31581C5Cb?Mode=Embed" Width="640" Height="480" Allowfullscreen="True" Webkitallowfullscreen="True" Mozallowfullscreen="True" Frameborder="0"></Iframe>
Statistics
Likes
11
Downloads
0