Triforce Bracelet

Triforce Bracelet

Description

Simple Slide-On Bracelet With Triforce Insert. It Is Scaled To Fit My Own Wrist Snugly (With My Arm Sticking Straight In Front Of Me And My Palm Facing Down, My Wrist Is Approximately 60Mm From Left To Right And 45Mm From Top To Bottom). You Will Probably Need To Scale The Bracelet Up Or Down To Fit Your Wrist. Scale Uniformly In All Axis (To Keep The Triforce Insert Triangular), And Don'T Forget To Apply The Same Scale To The Triforce. The Triforce Is Designed To Snap Perfectly Into Insert (You May Need To Scale It Up Or Down If Your Printer Dimensions Are A Little Off). The Bracelet Should Be Printed At 0.2 Layer Height Or Lower With No Infill (To Give It Some Flex) And 2 Shell Perimeters (I Used A 0.4 Nozzle). The Triforce Should Be Printed At 0.1 Layer Height Since It Is Slightly Curved (To Match Bracelet Curve), And I Printed It At 100% Infill. I Printed This In Hatchbox Wood Pla And Some Random Unbranded Orange/Yellow Pla (See Post-Processing Section Below For Wood Stain)

Statistics

Likes

56

Downloads

0

Category

Bracelets