AM8 Y Rod Holder w/ Endstop. Compatible with Reprap Champions Anet A8 Carriage
Description
This Is A Y-Rod Holder With Endstop For The Am8 Upgrade That Is Compatible With The Reprap Champion Carriage For The Anet A8 It Brings The Endstop Forward 10Mm And Leaves A 2Mm Safety Distance From The Y Motor Mount. This Is The Same Safety Distance As The Original Carriage. I Would Recommend Only Setting Your Printer'S Y Build Volume To 210Mm. This Leaves A 2Mm Safety Gap From The Original A8'S Slide Bushings From Hitting The Front Extrusion. With The Default 220Mm Bed At A 210 Mm Build Volume, I Recommend Setting Your (0,0) Point 5Mm From The Front Of The Bed By Sliding The Side Extrusions Into A Position That Allows It And Then Setting It In Your Firmware. This Will Setup Correctly Centered Prints.
Statistics
Likes
28
Downloads
0