Wahl "0.5" guard
Description
This Guard Fits Wahl Brand Clippers Sold At Costco. This Guard Is Slightly Closer Than A #1. I Like To Call It A #1/2 But I Do Not Actually Know. I Printed This In Grey Hatchbox Pla. Printing: I Printed It On It'S Small Edge To Maintain Strength Where The Clippers Need It The Most. My Printer Also Likes To Steal ~0.5Mm In The Z Due To The Heated Glass Bed So Printing It On The Side Kept The Blades From Being Weakened. I Printed It At ~50Mm/S, 0.1 Layer Size, 15% Infill, 15% Support And 1.2Mm Walls. Printing On Edge Requires Support. Design: I Did The Fit Of The Clippers Face First. I Then Drew A Master Blade In The Plane Of The Guard Edge To Meet My Length Requirements And To Fit The Clippers. This Was A Connected Poly-Line That I Extruded To Form My First Blade Right On The Edge Of The Clippers. I Multiplied And Transformed The Blade Across The Tip Of The Guard And Added Support To The Blades On The End For Extra Strength And To Hold The Clippers Better. I Then Filleted The Sharp Edges To Make It A Bit Nicer On The Scalp.
Statistics
Likes
42
Downloads
0