Lambent Light Sheath
Description
As My Copy Of Lambent Light Nears Completion, I Decided It Needed A Sheath To Carry It In At Animeexpo. Designed To Fit Camaleonte'S Remix Of Microwavabletofoo'S Design. First Of 4 Pieces Being Printed Now. Screenshot Above Shows The Thick Trim Detail Piece For Scale. .35Mm Layer Height 160Mm Print Height Required No Support Material Needed Edit: Sheath Fits The Blade. Looks Like There Is Space For Foam Lining To Limit The Sword Rattling. I Had Some Roughly 1/4 Inch Foam That I Cut Off About A 1.5 Inch Strip And Glued To One Side Inside The Sheath. It Does Help Eliminate Rattling Quite A Bit, But It Was Too Tight To Add On Both Sides. 1/16Th In Foam Or So Would Be Better. Edited Sheath 1 Section To Make The Detail A Little Bigger. Just Looked Too Small When Printed. Note: Battle Tested, Survived 2 Full Days At Ax Convention With No Problem Once I Got Enough Ca Superglue Bonding The Pieces Together. Glad I Added The Strip Of Foam Lining To One Side.
Statistics
Likes
40
Downloads
0