Lulzbot Mini Side Pocket
Description
I Looked Around For A Tool Holder For The Accessories That Came With The Lulzbot Mini. When I Did Not Find One That I Like, I Decided To Design One Myself With Freecad. Some Of The Design Goals Are: • Tool-Less Installation And Removal • Out Of The Way Of The Acrylic Enclosure • Out Of The Way Of Any Moving Parts • Maximize Functionality While Minimizing Filament Weight • No Support Generation Required Available Slots: • 25X3Mm (Clam Knife) • 25X10Mm (Pliers) • 18X9Mm (Dial Caliper) • 12X8Mm (Tweezer) • 30Mm Dia. (Fat Glue Stick 22G/0.77Oz) • Two 10Mm Dia. • Two 1/2 Inch Dia. (Sharpie Marker) • General-Purpose Pocket Installation: • Push Bottom Down At An Angle Onto The Mini'S Frame • Push Top Inward To Snap Into Opening • Slide Toward The Front To Engage Clip Give This Design A Try. Please Leave A Comment Or Send Me A Message If You Have Suggestions For Improvement.
Statistics
Likes
19
Downloads
0