MGN12 Tevo Tarantula Y-Axis Mount
Description
I Liked The Original Design So I Chose To Modify It A Little. Bom: 1X Printed Mgn12 Y-Axis Carriage 4X M3X10Mm 4X Heatbed Adjusting Screw [From Old Assembly] 1X Heatbed [From Old Assembly] 1X Acrylic Heatbed Mounting Plate [From Old Assembly] 4X Screws With Nuts [From Old Assembly] Instructions: 1) Remove Old Heatbed, And Carriage. 2) Mount Mgn12 Rail To The 2020 Profile Using At Least 3 T-Nuts 3) Mount The Printed Mgn12 Y-Axis Carriage With The Four M3X10Mm Screws To The Carriage Block 4) Mount The Acrylic Heatbed Mounting Plate To The Printed Mgn12 Y-Axis Carriage With The Four Screws And Nuts You Salvaged From The Old Assembly 5) Install Heatbed With The Four Heatbed Adjusting Screws. Check The Heatbed Correctly Adjusted. Done! Description: This Part Saves Z Height Over The Original Due To Recessed Screws (The Ones Used To Mount The Mgn12 Adapter To The Mgn12 Carriage Block. Also The Belt Is Attached At An Angle If You Use The Motor Mount And Y Axis Tensioner From Banholm, So I Lowered It A Little And Now The Belt Is Perfectly Parallel To The Mgn12 Rail. Belt Tensioner: Https://Www.Thingiverse.Com/Thing:1704100 Motor Mount: Https://Www.Thingiverse.Com/Thing:1704123 Additional Information: .Iges Is Also Available For Download If You Want To Modify The Part.
Statistics
Likes
47
Downloads
0