Bracket for mounting RichRap's Greg's geared Bowden-extruder to 0.75" square-tube (like on a RigidBot)

Description

Bracket For Mounting Richrap'S Greg'S Geared Bowden-Extruder To Rigidbot (Or Any 0.75 Inch Square-Tube Frame) Richrap'S Thing: Https://Www.Thingiverse.Com/Thing:60531 I Used #8-32 Screws, But You Can Use An M4 Also (They'Re Essentially The Same Diameter). The Part Is About 28.6Mm, Or 1.125 (1 And 1/8Th) In Width, So Your Screws Must Be Longer Than That, Plus The Thickness Of The Extruder Plate (3/16Th Inch Or 5Mm). I Recommend A High Wall-Thickness And A High Density, For Strength. Print However You'D Like Aside From That.

Statistics

Category

Tags