Fidget spinner
Description
Made A Fidget Spinner With Washers And Bolts As Weight, Instead Of Bearings. This Way Will Save You The Use Of 3 Bearings. The Bolts Are M4X8 Mm, And The Nut Is A Square M4. The Washers Are Ø18 Mm. Bearing: Abec-7 608 Rs, All 608 Bearings Should Fit. Print Setup: Material: Innofill Pla Silver (All "Hard" Materials Should Be Fine) Heat Nozzle: First Layer; 205 C , Afterwards 200 C Heat Bed: Non Nozzle Size: 0,3 Layer Height: 0,15 Support Under Each "Washer Space", If Your Printer Is Good At Bridging It Should Be Possible Without Support.
Statistics
Likes
3
Downloads
0