Fidget Spinner
Description
These Can Be Printed In Two Colours And Different Types Of Filament With A Single Extruder If You Print Off Half And Then Switch Filament. These Were Made To Have A Tight Fit So The Bearings Do Not Fall Out. A Suggestion Would Be To Use The Back Of A Screwdriver E.X. To Bang In The Bearings. You Also Don'T Even Need To Put Bearings In The Outside Ones. You Could Just Print Off Something That Is 22Mm In Diameter. This Was Made In Fusion 360 And Printed On The Anet A8. Print Off 2X Half The Spinner 2X 1 Cap This Fidget Spinner Uses 608 Bearings (22Mm In Diameter) Or Print Off Fake Beaings.
Statistics
Likes
5
Downloads
0