3FPD-Replicator 2X - Extruder Upgrade - REV4

3FPD-Replicator 2X - Extruder Upgrade - REV4

Description

This Is An Extruder Upgrade Designed Specifically For The Replicator 2X, But With Improvements Like It Is Now Suitable For Use With Flexible Filaments!!!! *** Ok...01May14, We Have Used A Highly Modified Recreus Hot End Kit (By Chopping The Aluminum Heat Sink Fins, Tapping The Thermistor Hole To Fit A Std Makerbot One, And Insulated It) And The Rev4 Extruder Works Out-Of -The-Box, But Not Optimally. We Will Be Releasing The Rev 5 Extruders, And A Newly Modified Fan Duct Rev 2 With A Modified Cooling Tube Back To The Extruders Which Has Made A Huge Improvement In Cooling The Area Around The Filament In The Extruder Area Before It Feeds Into The Hot-End Tube...*** -Base Is Fully Printable Without Supports(Rev4=Design Tweaks Include Enclosed Guide Tube To Control Flexible Filaments Like Filaflex, And Ninjaflex) -Arm Is Printable With Only External Supports For Bearing Slot(Rev4=Slight Geometry Tweaks) -Arm Integrates Feed Tube Mount As Well -Tension Spring Geometry Improved -Use 5/32" And 1/4" Bits For Tight Clearance Bearing/Arm Pivot Holes -Uses Makerbot Hardware Kit For Rep2 + 1 Extruder Screw ($8 Ea From Makerbot.Com) -Can Be Pre-Assembled For Quick Swap (Under 2 Minutes Each) -L And R Extruder Parts Included, And Labelled (Common Pin)

Statistics

Likes

51

Downloads

0