Joystick Enclosure
Description
This Is An Enclosure For A R/C Joystick. I Purchased The Joystick Board From Amazon. It Was Intended To Be A Arduino Shield But I Removed The Header Connectors And Will Solder Wires To Connect To A Arduino Nano Board. The Nano Transmits The Joystick X And Y Positions And Button Pushes Over Bluetooth. The Enclosure Clamshell Was Designed Using Openscad And Can Be Customized. The Bottom Piece Holds The Nano And Bluetooth Modules, A 9V Battery And A Power Switch. The Top Piece Has Four Tabs To Secure The Joystick Board. The Top And Bottom Pieces Have A Latch To Hold Them Together. A Small Cutout Allows Inserting A Screwdriver So It Can Be Pried Apart For Service Or Replacing The Battery.
Statistics
Likes
52
Downloads
0