Geeetech i3 Pro B Cooling Fan Duct, 40mm holes (50mm fan)

Description

Note That The Holes Are 40Mm Apart, The Fan Would Have 50Mm Edge Length, I Have Been Told These Are Sold As 50Mm Fans. Please Make Sure These Measurements Are Correct Before Buying A Fan. Rotate 135 Degrees Until It Lies Flat, The Pipe Looking Straight Upwards. When Slicing (At Least With Slic3R) You Might Need To Carefully Look Over The Layers Of The Conical Section To Make Sure It Will Print Everything With The Same Number Of Lines And Will Not Put Some Needless Additional Gap Filling Island Here And There. I Had To Slightly Tweak My Perimeter Extrusion Width Until It Would Slice This Entire Section With 3 Lines Everywhere And Could Make Every Layer With 3 Smooth Uninterrupted Circles Without Small Islands Of 4 Lines Or 2 Lines, Causing Blobs And Other Artifacts, This Can Happen Due To The Slightly Changing Wall Width Of The Loft In Some Areas.

Statistics

Category

Tags