Da Vinci PRO E3D V6 Carriage: Single/Dual Extrusion
Description
This Is The Final Version! ((Coming Soon: Ultra Narrow Version!!!!) It Uses Lm8Uu Bearings. The 4 Holes Are 15Mm (14.95) Diameter And 15Mm Wide! Note: The End Stop Tab Works Great, And Will Need Trimmed Because It'S Too Long, And Also, May Need To Be Painted With A Paint Marker To Function Properly So That Light Cannot Pass Through! Find Us Here And Share Info Of Your Modded Da Vinci Printer! Https://Www.Facebook.Com/Groups/Produino/ Fyi, This Fits 8Mm Rails (With Lm8Uu Bearings) Spaced 70Mm Apart. The Rail Track Is Horizontal. Single And Dual Extrusion Carriages For Da Vinci 1.0 / 2.0 ? / Pro Printers With A Bowden Setup. For 1 Or 2 E3D V6 Hotends The Spacing Between Dual Hotends Is 25Mm ! Dual Setups Only Work With Arduino/Ramps Setups, Not With The Original Pro Board. Requires 75-80Mm X M3 Bolts (Quantity 2) Lm8Uu Bearings (X4) One Small Zip Tie To Hold The Belt To The Carriage. Please Print All Clamp Pieces "Open" Side Up!!!! ('U' On Top) A Cooling Fan Of About 40-50Mm Should Easily Adapt To The Front.... 12V For Ramps 1.4 Setups. With The Dual E3D V6 Setup, The Left Side Is Slotted, And Z-Axis Is Adjustable In Comparison With The Fixed Right Side. Adjust Before Tightening.
Statistics
Likes
43
Downloads
0