Bowden Hotend Clamp for Vulcanus V1
Description
I Didn'T See The Point In Using A Direct Drive Extruder On The Vulcanus V1, Especially The One That Was Suggested Since That Extruder Probably Wouldn'T Work With Flexible Filaments, Plus Bowden Extruders Are Faster. So I Made This Hotend Clamp That Allows You To Use A Bowden Extruder (With A Hotend That Is Designed To Be Used W/ A Bowden Extruder). This Clamp Should Prevent The Bowden Tube From Slipping Out Of The Hotend, Provided That Your Hotend Has A Bowden Tube Fitting Built Into It Like Mine (E3D V6), And It Should Also Prevent The Bowden Tube From Getting Bent Too Much Near The Hotend, Which Can Sometimes Cause Under-Extrusion. To Install, You Will Need Two M3X20Mm Screws, Two M3 Hex Nuts, And The "Corexy_X-Carriage" Part Designed By Vulcaman For His Vulcanus V1 Printer. I Designed This To Fit The E3D V6 Hotend, I Can'T Guarantee It Will Fit Any Of Its Clones.
Statistics
Likes
1
Downloads
0