Sawed off shotgun airsoft shell adapter for pps shell
Description
This Is An Adpater To Fit A Pps Airsoft Shotgun Shell Into The Sawn Off Shotgun. The Original Sawn Off Shells Are Utter Crap. My Customer Asked Me To Build This. Basically, It Is Inserted All The Way Down In The Chamber And You Can Put In The Orange Pps Plastic Shell Or The Pps Purple Metal Shell. (Sorry For The Upside Down Photo, Took It With My Cellphone And Apparently Thingiverse Is Messed Up) 1-Print The Nozzle Down With Support. 2-Sand The Nozzle So It Fit In The Rubber Chamber Of The Sawn Of. 3-Do 1 Full Roll Of Electrical Tape From 0.5 Inch To The Bottom Of The Adapter. 4-Insert It In The Barrel, It Should Hold In Place But Not Be Too Hard To Insert. (If It Gets Stuck, Do Not Worry, Use A Rod And Push The Whole Barrel Assembly From The Exit Of The Barrel. The Whole Thing Will Come Out) 5-Edit 26/11/2017: Go And Print My Shell Extractor! Forget The Electrical Tape. I Never Had The Time To Upload It Here: Https://Www.Thingiverse.Com/Thing:2673466 6-You Might Need To Sand A Little The Inside Of The Tube Of The Adapter To Make It More Soft. If You Print In Smaller Resolution, You Probably Won'T Have This Problem. ***If You Want To Rework The Whole Thing, Check My Other Things For The Sawn Off Shell And The Standard 12 Ga Shell. (I Suggest For The 12 Ga Shell That If You Do A Boolean Difference, That You Increase Is Scale To 107% First)***
Statistics
Likes
7
Downloads
0