Moving Bed Strain Relief
Description
I Didn'T Like How The Wires Were Only Held By The Kapton Tape And Solder Joints On The Heater Pcb At The Back Of The Bed On My Anycubic Prusa I3 Clone So I Made This Strain Relief. It'S Designed To Lead The Wires 90° Around The Sides So They Would Move Along Next To The Y Axis Instead Of Above It. Mounting Is Easy: Turn Your Bed Around So The Wires Are Sticking Out To The Left, Then Hold This Part Where It Should Go And Drill 3Mm Holes Using The Holes In The Print As A Guide (They Are Spaced 20Mm Apart). Then Use 2 M3 Screws And Nuts To Fasten It. In My Kit There Were Plenty Of Spare Screws So I Used Two Of Those. Finally, Lead The Wires (With Or Without Some Kind Of Sleeving) Into The Groove And Fasten It With 2 Zip Ties.
Statistics
Likes
17
Downloads
0