Longshot Top Rail
Description
This Here Is Dartkrafts Remix Of The Blasterforgeph Nerf Longshot Top Rail Of Which Were Kind Enough To Give To The Community. But Alas, The Community Do Not Have Enormous Printers! So Dartkrafts Took It Upon Their Crafty Little Fingers And Split It Up Into Printable Parts For The Masses. It Has 5 Parts +2. Front End Piece, Front Left, Front Right, Back Left, Back Right, Plus Two Little Joiner Thingies. 4 M3 X 12Mm Black Self-Tapping Screws Are Required. Just Steal Some From Your Large Size Mellow Yellow Nerf Blaster (Stampede, Longshot Front Gun Etc) The Joiner Thingies Were Left Separate Intentionally As Designing Them Into The Rail Pieces Would Put Them Right On 200Mm, A Common Print Bed Size For Most. The Joiners Are Marked With A 'T' Meaning 'Top' As The Height And Width May Look The Same, But No, Good Sirs And Madams, They Are Not. So Insert The Joiner With The 'T' Facing... The Top Of The Rail. Please Glue The Joiners Into The 'Back' Pieces First. The Front Pieces Have An 11Mm Recess And The Back Have 10Mm. The Joiners Are 20Mm. If You Glue Them Into The Front First You Will End Up With Only 9Mm To Glue Into The Back. It Was Designed To Have A 1Mm Gap In The Front Pieces To Make Sure To Allow For Any Tolerances Being Over And So The Two Parts Could Still Come Together Snuggly. Dont Worry About Epoxy, Just Super Glue Em, But Work Fast As They Are A Tight Fit And Will Bond Hard Just About Instantly. If You Feel Safer With Epoxy Given The Extra Working Time, Then Go For It, Knock Yourself Out! Tested And Fitted. Works A Treat. Bon Appetite!!
Statistics
Likes
37
Downloads
0