Brushed 90mm Micro FPV Race Drone (SPRacing Evo, 8520 motors)

Description

I Tried To Design Something That Was Ridged, Durable And Light. So Far Its Taken A Few Pretty Heavy Crashes Into Concrete With No Noticeable Damage. This Is My 3Rd Design And The One I Am Most Happy With. Flight Characteristics Are Great With Very Snappy Cornering And Good Recovery From Diving. It Has A 20 Degree Camera Tilt Which I Find Is Perfect For These Micros. If You'Re A New Pilot This Might Be A Little High But I Find The Wide Viewing Angle Of These Cams Make The Tilt Less Of An Issue For New Pilots. Weight Is 40G Dead On. That Is Including A Micro Rx That I Needed For My Transmitter, Newer Flight Controllers Have Onboard Rx'S That Should Bring The Total Weight Down Significantly. Wheelbase Is 90Mm. I'Ve Also Added A Buzzer. I Learned The Hard Way That Leaving Them Off To Save Weight Is A Terrible Idea If You Plan On Flying Outdoors. I'Ve Printed In Pla, The Only Filament By Cheep Printer Can Handle. Abs Might Be A Better Option. I'D Appreciate The Feedback If You Try It. Parts List: Flight Controller: Spracing Evo Brushed Motors: 8520 Coreless Camera: Not Sure, Its A Standard Micro Cam Vtx Combo Job. Any Should Fit No Problem. Props: Ladybirds Buzzer: 5V Buzzer Misc: Foam Tape For Mounting The Fc, Rubber-Bands Build Should Be Straightforward. Just Use My Photos For Reference. I Highly Recommend Flashing The Latest Version Of Betaflight Onto Your Flight Controller. Instructions Are A Google Away. Pids For Bataflight: These Are The Ones I Found For The Qx90 Micro Quad That Is Also A 90Mm X Frame. They Seem To Work Very Well. P_Pitch = 80 I_Pitch = 45 D_Pitch = 20 P_Roll = 80 I_Roll = 45 D_Roll = 20 P_Yaw = 75 I_Yaw = 45 Credit To Nj Tech For Those Updated For A Bit More Strength. Added About A Gram Of Weight Edit I'Ve Added A Wip Design That Should Be An Improvement. Not Fully Tested Yet. I'Ll Keep Uploading As The Design Changes

Statistics

Category

Tags