GoPro Plastic Bottle Cap Mount
Description
Gopro Plastic Bottle Cap Mount The Idea Is To Use Any Plastic Bottle As A Grip/Stand/Floaty At The Same Time. I Saw Plenty Of Solutions Here On Thingiverse As Well, But I Did Not Find Any Of Them Perfect. The Concept Is Brilliant, You Get Basically A Free Gopro Grip, Which At The Same Time Makes Your Camera Float. Though A 3D Print Is Most Likely Not 100% Watertight, It Is Good Enough To Make Your Gopro Float In Water. I Designed It 3D-Print Friendly, But Also With Common Engineering Sense: - No Need For Supports, The Big Inner Overhang Is Sloped - Sharp Edges Are Rounded: Especially Important In High Stress Areas - Also The Edges Sitting On The Printbed Are Smoothened: They Could Cut Your Hand Otherwise When Tightening The Cap - Walls Are Thick Enough That Some Infill Will Be Printed To Get A Sturdy Part (Two Other Prints I Tried From The Site Where Bendy, Weak) - Yet Tried To Keep Size To The Minimum Not To Get A Bulky Part - Surface Is Grooved To Create Better Grip I Used The Standard Thread Called Pco1881. This Is The Newer Style - Lightweight And Lower Profile, Against The Older Pco1810. Outside Diameter Is 27.4 Mm And Pitch Is 2.7 Mm. The Drawing Was Printed, Used And Tested Diving In A Lake With The Gopro Session And I Was Satisfied With It. I Hope You Will Enjoy It!
Statistics
Likes
146
Downloads
0