Z Motor Mount
Description
This Is A Simple Motor Mount For A 2020 Extrustion That Allows You To Mount The Z Stepper Motors Vertically. There Is A Notch On One Face That Allows The Wiring Connector To Slide In. Note: You May Need To File A Tiny Bit Of Both Sides Of The Notch To Get The Motor To Sit Flat On The Bottom Face. Otherwise, You Will Be Scratching Your Head Wondering Why It Seems Bowed Out. But Better A Tight Fit Than A Sloppy One. Also, You Will Need To Epoxy It To The Surface, Or Find The Type Of Screws That Are In The Motor Bottom. They Do Not Seem To Be The Same As The 2Mm Screws On The Top, But I Did Leave Holes For Them Should You Find Them (Along With Some Washers) To Hold It Snugly In Place. If You Make One Of These, Feel Free To Post A Pic Of Your Build. Enjoy!
Statistics
Likes
12
Downloads
0