Two tuba mouthpieces
Description
Two Tuba Mouthpieces: - One Rather Funnel Shaped Mouthpiece (The Pink One), Not So Wide But Relatively Deep. A Bit Like A Pt-65. - One Quite Cup Shaped Mouthpiece, A Bit Like A Mirafone C4. 32.5Mm Inner Rim Width, Rounded Rim Inner Bite. I Don'T Really Like The Funnel Shaped One On My Conn 12J, But The Cup Shaped Mouthpiece Plays Really Easily And Sounds Quite Good. Print With The Cup On Top, With Support Enabled. It Should Only Print Support Under The Horizontal Plate. The Support Is So It Does Not Fall Over During Printing. Break Off The Plate After Printing, Should Be Easy To Do. Print At A Fine Layer Height. 0.05Mm Works Well. If You Have A Slicer With Variable Layer Height, You Can Save Time And Print The Rim With More Detail Than The Rest. Then Sand The Rim And The Inside Of The Cup, First With Coarse Grit Sandpaper, The Finer Until You Reach 600 Grit Sandpaper. Sanding The Rim Makes It More Comfortable To Play, Sanding The Inside Of The Cup Makes The Sound Better. The -No-Support Versions Are Without Support, For Example If You Want To Print On Something Else Than Extruder-Based Printers.
Statistics
Likes
6
Downloads
0