Support for a wall-wart that sticks out from a power bar
Description
Our Elliptical Machine'S Wall-Wart Was Sticking Out Far Past The Edge Of The Powerbar It Was Plugged Into, And Kept On Falling Out. This Is A Quick And Dirty Support For It. After Printing, Just Zip-Tie Or Duct Tape The Wall-Wart To The Enclosed Squarish Part. It'S Customizable Since It Is Unlikely Your Power Bar And Wall-Wart Will Have The Same Sizes. No Supports Needed. I Printed In Abs With 50% Infill For Durability, But It Was Probably Overkill.
Statistics
Likes
2
Downloads
0