Nodal Ninja 3 kit to provide 6 degree detent
Description
A Friend In The Us Asked For A High Res Image Of Sydney Harbour Bridge And Opera House For Blowing Up To About 4Ft X 8Ft. The Minimum Angle Available On The Standard Nodal Ninja 3 Detents Is 15 Degrees Which Was Not Fine Enough For My Needs. Hence This Design Which Provides A 6 Degree Detent. And Here Is The Result: Https://Flic.Kr/P/Wywkkf Designed In Moment Of Inspiration (Moi3D) And Printed In Petg On A Prusa Original I3 Mk2 And On A Kodama Trinus. Simplify3D Slicer Used For The Trinus And Prusa Slic3R Used For The Prusa Original I3 Mk2 4 Colour. The Detent Plate And The Pin Need To Be Made From A 'Hard' Material. I Think That Pla Would Be Ok But I Doubt That Parts Made From Abs Would Last Very Long. The Design Needs Hardware. I Used: 7-Off 3Mm X 10Mm Long Button Head Cap Screws 1-Off 6Mm X 35Mm (Under The Head) Socket Head Cap Screw 1-Off Compression Spring. 7Mm Diameter, Free Length 20Mm, Solid Height 5Mm. 6 Full Turns. Wire Diameter 0.5Mm. A Brief Video Is Here: Https://Youtu.Be/Jpqh2Qbtuew
Statistics
Likes
11
Downloads
0