Hubsan H501A/H501S Extension Legs
Description
I Drew And Printed Up Some Legs For My Hubsans To Get Them Further Off The Ground (Both For Prop Clearance In Higher Grass And For Ground Clearance For My Runcam Split). If You Want Them Longer Or Shorter, It'S Easy Enough To Change That Size In Your 3D Printer'S Slicer. I Picked This Particular Size As It Is The Minimum Size Which Allows Ground Clearance For My Runcam Split At Any Angle. I'Ve Attached Them With 2 Small Zip Ties And Then (Because I'M Persnickity), I Uv Welded Them In Two Spots. If You Tighten The Zip Ties Well Enough There Is No Problem, But... With The Uv Weld, They Won'T Budge (With The Added Benefit That A Quick Snap Of The Wrist Breaks That Weld If You Want To Remove Them). Everything Total (Legs And Zip Ties) Weighs In At 14G And Doesn'T Make Much Difference In Flight Time. As Always, I Printed These With Petg. I Went With 10% Infill, And Trust Me, They Are Strong!
Statistics
Likes
29
Downloads
0