Spektrum DX6 Stand
Description
* Had To Print On 45 Degree Angle To Get A Good Print. Printing Flat With Supports Didnt Work, Support Were Too Hard To Remove. This Worked Perfectly. Couldnt Find A Stand For The Newer Spektrum Radios, So I Decided To Make One. I Dont Fly Spektrum, But A Good Friend Does, I Borrowed His Radio To Make This. The One Caveat Is That You Need To Wrap The Area Under The Clip With 1 Layer Of Silicone Tape. I Had To Do This Because The Handle Is Not Round And I Need The Stand To Swivel. I Tried Making Collets, But They All Ended Up Being Too Big. I May Revisit The Collet Idea Later. This Solution Works Nicely And If Done Correctly You Dont See The Tape. You Could Use Electrical Tape, But Then Your Radio Gets All Messy. The Clip And Holes Are Made For Standard M3 Button Head Screws.
Statistics
Likes
24
Downloads
0