Anet A8 X-Axis Belt Aluminum Holder
Description
* The Included Stl File In This Post Is A Dummy File Of 1/16 3/4X3/4 By 62Mm In Length L Shaped Aluminum Angle So That A Picture Can Be Posted. See Below: Anet A8 X-Axis Belt Aluminum Holder Made Out Of 3/4X3/4 Aluminum L Shaped Angle Cut With A Dremel Rotary Tool. Just Used 1/16 3/4X3/4 Aluminum Angle Cut To The Width And Rest Of The Slots Cutout Using Dremel Rotary Tool With A Grinder Wheel. To Give Better Idea I Added A Rough Drawing Based On The Created Bracket That Was Cut Without Being Previously Drawn Out, Basically I Just Winged A Prototype Without Drawing, Just Used Estimated Measurements. As You Can See This Is Pretty Much To The Size, But It Is Missing Mounting Holes At This Point, Which I Believe Can Be Drilled At A Fitting. I Do Not Believe That This Thing Should Be Made Out Of Any Kind Plastic. I Think I Might Make A Slight Modifications To Its Sizing Dimensions To Make The Belt Be More Parallel To Have A Slightly Better Performance.
Statistics
Likes
2
Downloads
0